View
Dimensions mm
- Height
- 64.50
given
- Width
- 40.50
given
- Depth
- 12.85
given
- Opening Ø
- 22.30
given
- Ring inner Ø
- 19.00
given
- Face to ring
- 1.65
given
- Label
- 24.90 × 21.75
given
- Disc Ø (no chamfer)
- 13.40
given
- Ring to disc
- 0.65
given
- Contact from end
- 17.9
video
- Plastic rim Ø
- 15.1
8 photos
- Rim below disc
- 0.10–0.30
8 photos
- Valley floor below face
- 4.6
pressed photo
- Valley wall draft
- 30°
pressed photo
- Bottom fillet R
- 0.6
pressed photo
- Spring travel
- 1.4
pressed photo
- Plunger clearance
- 0.05
photo
- Logo T bar
- 9.19
8 photos
- Corner R
- 5.0
video
- Fillet front / back
- 2.0 / 1.8
video
- Seam from back
- 4.93
video
- Pocket from USB end
- 7.9
video
- USB-C receptacle
- 8.34 × 2.56
spec
- Plug stops at
- 4.35 deep
4 photos
- Plug metal showing
- 2.2
4 photos
- Cable overmold
- 13.2 × 6.5 × 20.2
photos
- Boot · cable Ø
- 5.4 → 4.6 · 3.5
photos
Outer plastic carries a fine spark-eroded grain; the contact bore, USB-C opening and label pocket are smooth. The steel ring's outer edge runs under the plastic, so the bore wall meets it without a gap. The sprung plunger is a steel disc with a stamped logo; its black silicone fill sits about 0.015 mm below the steel face and dishes slightly towards the middle of each stroke, set in a thin smooth plastic rim, sprung about 1.4 mm deep into a wide, drafted valley with a filleted floor. The label is a black-on-white laminate, raster-engraved line by line and pressed into its pocket. Inside the USB-C port the dull contacts sit flush in the matte black tongue, which rises from a black insulator at the back; the steel mid-plate edge runs flush along both tongue ends, and four thin arch-shaped metal tabs of the shell are bent flat onto the bottom of the port, each leaving a small opening against the long walls either side of the tongue.